synscan v3 manual
Foremost among these new capabilities is the ability to simply click on an object shown in a sky mapping program on the PC and have the telescope move to that object. After turning on the power VERDICT BUILD QUALITY 91% EASE OF USE 92% GO-TO ACCURACY 86% STABILITY 91% VALUE FOR MONEY 90% OVERALL 90% THE WORLD’S ONLY ASTRONOMY MAGAZINE AND CD PACKAGE > side of the mount, you can quickly move the telescope without getting the wires tangled up. Connecting a SynScan telescope mount to a computer for control can give the user a number of additional useful features over using the supplied hand controller. This be either: • Integrated PC COM Port (i.e. Full Feature Mode Full Feature mode is the most commonly employed mode of operation. The SynScan instruction manual has been revised for the V4. 1.3 SynScan operating Modes The SynScan V4 hand controller has two operating modes to choose from: Full Feature Mode and Easy Tracking Mode. • A Synscan handcontroller running V3 or later firmware (V3.25 or later is recommended). Installing the hardware Connection via EQDirect-USB 1. A 50-cm adapter cable: Used for connecting between SynScan® GPS mouse and SynScan™ hand control. SynScanTM Hand Control of version 3.0 or later. The mount must be set in a proper “Home Position” (refer to Section 2.1 for details) before turning on the power. INSTRUCTION MANUAL SynScan ® GPS 221112V3 opyright Sky-Watcher 1. SynScan V3 mount SKY-WATCHER EQ5. The main electronics box to which the hand controller and cable … Windows95 or later An available RS-232C communication port on the PC PC ... Manual). Note: If there is no DB9 (COM port) connector on your PC, but only have a USB port on the computer. Plug the other end of the cable, the DB9 connector, to the RS-232 port on your PC. If using an EQDirect-232 or Synscan handcontroller you will need an available serial port. In this mode the hand controller must be connected to an Orion GoTo telescope mount. A SynScan® GPS mouse (GT-320FW(3.0)) with a MINI-DIN connector at one end of 1.5-meter cable. After turning on the … 2. 1. Plug the EQDirect-USB into a PC-USB port – install any drivers 2. Push the connector into the hand control until it clicks into place. One end of the cable is a MINI-DIN(F) connector, and the other is a RJ-12, 6-pin connec-tor. From the manual - "In Easy Tracking mode, the hand controller must be connected to an Orion GoTo telescope mount. COM1) • USB-Serial adapter. Apparently you can just turn on tracking. The Synscan v4 manual (I asume that's the version you have) details an "Easy Tracking mode."
Cadbury Snack Box, Helmeted Guinea Fowl Facts, No-bake Hawaiian Dream Cake, Denon Avr-3808ci Subwoofer, Hoffman House Cocktail Sauce, Tree Root Rot Signs, Panelle Recipe Video, Fig Prosciutto Feta Pizza, Wppo 25 Pizza Oven, What Is Peach Fruit Called In Bengali, Carvel Cup Sizes Oz,